After extruding the plastic pipe, why is it not soaking, cooling, spraying cooling?
You can verify that if you take soaking and cooling, you need to constantly add water, otherwise the water temperature will soon rise
No, because the extruded pipe after pipe through vacuum sizing and cooling set has been basically finalized, will not appear out of the pit to save water and electricity, spray cooling, full immersion cooling is the main post, when your products quickly is not spray cooling, can full immersion, but to control the temperature,
Can use the groundwater cooling tank drain principle of plastic products in the water if not dry can be installed fan can be connected with the water inside the drum roller device trouble a little but good results can add fan is small fan but I often refitted in plastic factory processing
