Angle valve bathroom cabinet is used inside or outside the wire
The angle valve is all outside the wire interface. If you have more questions, click ID.
Triangle valve generally used outside the wire, including shower faucet, toilet water control principle is right, in the end, one end, the other end is the earliest faucet knob, a principle; also in the decoration process, sometimes another elbow angle valve interface sleeve in the wall is too deep, angle valve the silk mouth is not long enough to use directly installed inside and outside the wire extension to
5, waterway layout, installation, should be tested on the spot pressure, the test pressure will be hot and cold water pipes and together to test pressure, test standards are generally: 30 minutes 8 kg, allowing pressure drops 0.6 kg.6, Shoufang should check the kitchen and toilet each outlet is smooth, if slow drainage should be timely to let the property dredge; should be protected on the drain during the renovation, especially during the tiles on the kitchen, the most easy to cause the fall into the drain caused by the blockage of cement;7, puwan tile kitchen after the water should check, look at the floor drain is smooth (to remove floor drain cover drainage speed prevail, because most are deep water leakage drainage fief slowly.);8, if the excess must be closed drain, drain and drain blocked the gap between, to prevent water spill down;9, water installation, after installation of water faucet to electric water heater, etc. for cold and hot water pipe should pay attention to four points: (1) to ensure the spacing of 15 cm (now most of the electric water heater, water faucet and hot water water spacing is 15 cm, there are 10 centimeters); (2), cold and hot water pipes on the same height; (3), cold and hot water pipes in vertical wall after wall should also pay attention to don't let Wagong warped (not vertical, after installation can be difficult); (4), cold and hot water outlet pipe should be high the wall is two cm, also should be paved with tiles puwan tile Wagong requirements, to ensure the same level of pipe wall and pipe. The size is not appropriate, after installing water tap water heaters, etc., it may need to purchase another hoop, wire connectors to complete installation;10, bathroom floor must not forget to do waterproof, waterproof treatment should not be painted directly on the water pipe, otherwise, paint odor will permeate the water inlet pipe.The answer is recommended by He Yong, a healthy lifestyle classification
Angle valves used in bathroom cabinets are now widely used outside the angle valve.The water circuit layout needs to consider some questions as follows:I. waterway section1. The design of a waterway requires all the equipment related to water, such as water purifiers, water heaters, kitchen treasures, toilets and sinks, etc., their location, installation methods, and the need for hot water;2, in advance want to use gas or electric water heater, to avoid changing the type of water heater temporarily, resulting in repeated arrangement of waterways;3, in addition to leaving the bathroom sink, toilet, washing machines and other water outlet, it is best to take one out, after the water, mopping the floor and so on very convenient;4, after washing machine location is determined, the washing machine drainage can consider to make the drainpipe inside the wall, beautiful and convenient;
