Where is the pressure sensor installed? What are the technical requirements for pressure sensors?Thanks
With a three pass to the sensor is connected to the gas tank, pressure can be obtained, and then use the single-chip to control the motor start stop, keep constant pressure, our company is doing the "auto inflator" cable is to use this principle to control the pressure in the cable. If you have any further questions, you can send messages
The gas tank is usually pure gas, can think tank at the same pressure, so the installation position generally does not affect the output of the sensor, unless the jar height is very high, we cannot ignore the gas pressure.The sensor is not normally installed at the vent valve position. Because the pressure is abnormal when the gas is released. The pressure sensor has national standard and national standard, so it can be referred to. When selecting the measuring range of the sensor, be able to bear the overload capacity mainly. At the same time to consider the installation of absolute pressure sensor or gauge pressure sensor.
The pressure sensor is the pressure detection in the gas tank in the gas tank system, sensor installation thread monitoring the current pressure from time to time in the pressure tube, then through the instrument display, when the pressure is too large or too small to set the alarm, the automatic compression or decompression, so as to achieve automatic management by computer directly. Control
