Automatic doors should be checked for daily use
1. Automatic door installation is completed, the user in the use of the process, must be marked on the door to prevent some people do not pay attention to the collision, causing harm.
2. Regularly check the controller, belt and other accessories. If the bearing is biased, the screw belt tightening situation, the controller on the motor output brake parameters are normal, once the problem is found in time for maintenance, and replace the damaged parts.
3. Regular maintenance and maintenance of automatic doors, clean the oil inside the chassis, dust, check the wear and tear of the various parts. If not from time to time maintenance, it will cause the small problem of automatic doors slowly develop into a big problem, thus affecting the normal use of automatic doors.
Automatic sensor door application is very extensive, a set of automatic doors after the installation is completed daily use, and automatic use of the door in the daily use of the best time or check the automatic doors, the saying goes, if a small problem dragged on for a long time Become a big problem, then the automatic door should check what day? The following OKorder Hongsheng Xinhui automatic doors for everyone to share the automatic use of the door should be checked what daily use.
If the automatic sensor door installed infrared anti-clip device, when the automatic door open, hand-blocked infrared sensor eye automatic door will not close.
Observe the normal movement of employees through the automatic door route, automatic sensor door sensor area should be in accordance with the staff to take the angle of induction.
The width of the induction door is greater than the width of the door when the automatic door is fully open. Normal go to a certain distance before the door will automatically open the door, and run to be smooth and mute
Automatic maintenance of the automatic door is to check whether the normal opening, closing, sensing area, the threshold is normal, there is no accumulation of waste and so on. Specific check items are as follows:
First check the sensor area is normal, the sensing area should be greater than the door, that is, in the door of the two diagonally diagonally into the door when the body can be sensed the existence of objects or objects.
And then the length of the normal opening of the door and the length of the closing time. Observe whether the normal opening and closing, opening and closing whether there is noise and so on.
If the door fitted with infrared anti-clip device, you need to check the anti-clip device is normal, like a lot of elevator doors above the anti-folder device. Check the time is best to use objects rather than the body directly to check.
Check the threshold whether there is scratches, automatic doors can not have too much near the dust, waste and the like. Timely check and clean, to avoid the door in the run of blocked, and run is not smooth.
