since i had a new filling done i have set of alarms in shops is that a coincedence
do no longer try to plug a water pipe under pressure. The water would be uncontrollable as quickly as you're making the 1st shrink interior the pipe. you may no longer in basic terms shove a provide up end right into a pipe that has water pushing back at you. If it is fed from the cistern on your attic it rather is going to be undesirable sufficient and you gets a multitude that should make a television sitcom look smart. yet once you're dealing with mains stress then it rather is going to be merely approximately impossible to do till now you flood the abode. while you're dealing with a water pipe that passes under the 1st floor or above the ceiling then you definitely threat making your wiring moist. that could desire to be a reliable sufficient reason for no longer taking opportunities. because of the fact the others reported: turn off the main substantial provide up **** if it is mains, isolate the tank feed if it is gravity fed.
If you're desperate enough to just close the pipe and fix it later you can cap the pipe. You can get a cap at any home improvement store. You'll have to solder it on, which means you will also need a torch and some solder. You can cut the pipe off flush, cap it and solder it.
check to see if a bandname was already taken, this website has alot of bands on it including very underground ones. some names Free Revolutionary Children's California New Society
Get a shark bite cap or shut of valve from a hardware store. They are a a new type of plumbing fitting that cost a few dolars each but require zero knowledge or experience to install. just get a cheap pipe cutter to make a smooth edge on the pipe and push the cap/connector/shutoff valve on. try bringing a piece of it with you to the store, for sizing. Compression fittings are also available that are simpler than learning to solder. these just require some wrenches and a nice clean cut pipe edge.
