Electric curtains can not install intelligent systems
The small end nut is adjusted to the outer end, and the B edge of the steel wire passes through the small end head pulley.6 wire rope A side line first in the main C tablet pressing pulley, tighten the C screws. Then the B side of the steel wire rope is sheathed in the main pulley, and the main pulley is pushed by the side of the steel wire rope.7 will be required for the ball and stopper into orbit. The small end caps into the ends of the rails, tighten the retaining member. At this time the tension rope B side, and the wire rope compression in the D under the compression, tighten the D screws.8 drag the main and auxiliary blocks to the two ends of the guide rail and tighten the fastening screws on the auxiliary pulley.
3 will stop and the ball into the track, tighten the retaining member.4 loosen the auxiliary pulley screw, the wire rope B side through the middle of the two pressure plate screw, this time to promote the auxiliary pulley, pay attention to the wire rope should be kept on both sides of the pulley pulley
Yes, installation method:The driving wheel 1 rope through the big end.2 will guide into the big end, and the wire direction (do not cross) on both sides to pull to the side rail.
