HiMotherboard: Asus P5KCCase: NZXT Alpha My problem is the PWR LED connector, as the connector wire from the case is ( .l.l.), however the Mobo slot for it is (.ll.), with a blank in the middle. how would i make it fit and can i just leave it out?
Ok, I have had this before, here is what you do You get a pair of needle nose pliers and you CAREFULLY break that connector into two pieces (two black plastic pieces). If you have two needle nose pliars, you can hold on to half of the black plastic connector while you snap the other half off with the second pair. I have had to do this a couple of times in building computers, no big deal. Just be careful to snap it IN HALFits not that difficult IF you are careful about it. The two connectors can then be put into their rightful pins. Just make sure you have the + and the - on the right pins.
You can live it out I had to with my case.
