Gypsum ceiling ceiling how to do
Install the trim panel
(1) skeleton for the metal keel, the general use of countersunk head nail screws fixed decorative panels.
(2) gypsum board installation. First measure the distance between the keel to determine the required gypsum board, cut the gypsum board with the side keel and the main keel with screws fixed together. Fixed attention to each plate should be from the middle to the surrounding radial fixed, not from the surrounding multi-point at the same time fixed to prevent the emergence of curved, convex drum phenomenon. Usually the long side of the whole gypsum board should be installed along the direction of the keel laying.
Install the side keel
The edge keel should be installed according to the requirements of the design and the lifting of the ceiling elevation control line. Install the edge of the keel on the side of the wall after brushing the adhesive, the top of the wall with a drill hole, the wooden brick with a hammer into the wall, and then fixed with cement nails or screws in the already embedded wood bricks Brick to be treated by corrosion). Fixed on the concrete wall (column), can be directly fixed with cement nails.
Process:
Measuring the payline → fixed boom → installation side keel → install the main keel → install the keel → install the panel → install the mouth
Measure the pay-off: the laser level test equipment, measured the overall horizontal vertical line, and then according to the level of equipment far infrared, with ink along the wall (column) pop-up elevation control line. The purpose is to make the subsequent ceiling to be based on this horizontal line to ensure that the level of its vertical construction.
