My physics teacher told the class to do an analog sensor circuit. The circuit must have at least 2 analog sensors.What sensors are analog?And by the way, the circuit must NOT contain any digital components at all (so it can't contain IC, or anything digital)Thanks.
You should have your furnace serviced by a factory authorized professional. A seasonal service is not that expensive and they will make sure that your system is operating properly. Be sure to let the technician know about your concerns. The newer high efficiency models are far too complex to fix with no training. I typically do all of my own work, but that is one of the few areas that needs professional know how.
depends on the amp breaker at the pannel
ok well i painted the interior of my car and its really easy. if you have an air compressor and a spray gun, that would be the best way to go about doing this. if not, get a good name brand kind of interior plastics paint made for cars. your gonna need a couple cans of the colors you want, plus a couple cans of primer and clear coat. popping out pieces you want to paint is going to be easy. all your dash vents should just pop out with the use of a long tool. for example a screw driver. then your gonna find the screws that hold in your dash trim..like the piece that goes around ur cluster and probably down the passanger side of the dash. then you can find the screws that hold in your door panels. you might have screws in your lock part or the door handle part, but those are easy to get off. so when you have everything u wanna paint, ur gonna want to wash it very good first. and ur gonna want paint prefferable in an area that is dust and hair and dirt free. a clean,. non cluttery garage would be good. just wet the floor with water so any dust or dirt will land and will not be able to float back up. (water weight). so then your gonna want to sand the parts you want. sand it evenly with a light grit paper. what this does is smooth out the surfaces and makes the surface catch the paint better, so it doesnt run. then your gonna wanna spray the primer evenly. then once the primer dries, apply the desired paint evenly, as many coats as you desire to get the look you want. then when that paint is fully dry, apply the clear coat, to give it a glossy finish. then let it dry and move on to your next piece. and thats basically it. hope this helps.
