Awhile back i needed to replace a battery in my hard wired detector and my Boyfriend had a problem getting it off the ceiling and decided to just tug on it and broke the end of the connector which broke. I bought a regular smoke detector without the wires,and connector and replaced the old with the new. Is there a difference if i decide to change all with the one without the wires. I assume because it was new construction 15 years ago the builder had put these in, and I am not sure being I live in a community with an association attached to it, that i have to have the one that is hard wired or NO..Do i have to do anything to those wires left in the ceiling if i am not utilizing them.?
Its not a liquid!!!!! It's a foam, so it's already a solid, and freezing is defined as a liquid changing into a solid, so it can't freeze.
Where is the fuel pump safety module located? ain't got an inertia cut off in 88. i reviewed your other questions on this, just do this, open the hood. next to the diagnostic port is a connector box. jump terminals Fp and +B. turn the key to the start position. if the pump runs the issue is the circuit opening relay. toy doesn't call it the pump relay, but that's what it is. located up under the dash behind the glove box near the A pillar. if the pump doesn't run jumped, it's the pump, connector or associated wires going to it. that's assuming you have 12v power to the injectors. if not, could be the main relay. kick panel at your feet. if not, then ignition switch. owner 88 toy pu 4x4 22/20RE hybrid.
it is as dangerous as cooking!!!! I would not use the burners, I would use the oven with the door cracked ( 1/8 open ) just as you are instructed to do when broiling. If you have a hood, you might lose heat vs the stove method. If you bake bread for an hour at 475 degrees is this dangerous? Common sense it's cheaper.
