Hello, how do you change to the lamp with the energy-saving lamp ballast
Energy-saving lamp ballast break out, it is a small circuit board, rectifier circuit there is 220 v power supply cord, there are 4 lines, on the other side for the four wire tubes, each of the four lines connecting tube is ok, don't need to be paid attention to the two wires received tubes with end of the resonant capacitance
Two line tube, is to use built-in tubes resonant capacitance, resonant capacitance, do not use board so connection resonance capacitance of the two wires don't pick up, the remaining two output thread connecting tube of two electrodes.
CFLS use electronic ballast, for the two line tube, can fit the built-in resonant capacitance of the tubes, but cannot use the built-in bulb of the starter. A lamp tube with built-in regenerator can only be used for inductance ballast. The four-line lamp doesn't matter. It is also important to note that the power of the lamp tube should be the same as the power of the ballast.
