okay so i have a glass bowl. its rectangular and the carb isnt on the side like it usually is, its at the top. but anyways, yesterday i scraped my bowl out, to get enough for about 1 bowl, and i was wondering if i could do it again and get the same amount? but how? after awhile no stuff falls out when i know theres still some in there. what can i use to get the rest of the resin out so i can smoke it? yesterday i used a paper clip and an earring .
It is a flow of ions. The machine has two metals where a flow of ions occur. When the CO gas enters, the flow of ions is interrupted, and then the alarm goes off.
This could be the plastic piping called Pex. This product is sold in most big box stores. Regards, Dale
lock the door and unlock them with the key this should reset the alarm
There should be a valet switch of some sort. It will be a push button or toggle switch. You need to find this switch. It could be located anywhere, but most likely on the drivers side, under the dash possibly. You need to turn the ignition to the RUN position. This is the one before the START position that actually starts your car. (All the dash lights should come on when the key is in the RUN position) Anyway, you only have a few seconds to do this, but after turning the key to the RUN position, press the vallet button. If the alarm doesn't shut off, hold down the valet button. If there is a toggle switch, flip it one way. If it doesn't shut the alarm off, turn the key back and then back on, and flip it the switch the other way. Edit: You didn't say if this is the factory alarm or an aftermarket alarm. If it is the factory alarm, close the door and as someone else said, lock and unlock the drivers door with the key.
