Home wood flooring because of immersion tilt, how to do
Usually if the wood floor soaked in water, in the shortest possible time on the wood floor of the surface water to dry. At the same time take the vacuum cleaner in the water wood floor of the splicing gap suction water vapor, or take the dryer with cold air dry, but do not use hot air to prevent the surface caused by dry and dry deformation caused by dry. It is not advisable to reset the part of the wooden floor which has been drilled with water, and it is not recommended to re-paint the part of the arched, and then the paint will be re-painted. , And the thickness of the entire board uneven, force is different, prone to pits. If it is a large area soaked in water, should promptly notify the wood floor after-sales service, and try to keep the wood floor is not deformed in the case of the wooden floor carefully pry, according to "well" font superposition placed in the ventilation dry, with its The weight produced by the stack to prevent the occurrence of deformation, attention can not be placed under the sun exposure, under normal circumstances for better quality solid wood flooring can be used again. If it is a small area of ??soaked in water, it is recommended not to pry the floor to dry, so easy to cause hard damage to the floor, it is likely to cause serious consequences can not be restored. It is best to quickly remove the floor of the baseboard, exposing the expansion joints, by the expansion of the water vapor will be distributed, according to the size of different seepage, dry up usually takes about three to ten days.
With glue sticky, new ones.
Wood floor is blisters, if it is solid wood flooring, the following keel, so be sure to remove, so that keel dry, the floor in the indoor ventilation at the vertical dry, do not sun exposure, or roast, dry after no deformation Can be reloaded. If it is composite floor, high strength board. You have to start the floor to dry down, (but the premise is that the floor is free of plastic paved, played off the plastic from the waste), to see the specific Alice of the situation, if not very serious or Can be used, if more serious, it can only change the new. No matter what the floor was blistering are difficult to restore the status quo, are generally to Alice, but the degree of different, good quality will be better, it is difficult to restore the original, and soaked the floor of the water to the second Year in the summer or winter may be a drum or deformation of the expansion joints of the situation. It is best to buy the store you buy the same specifications for the same size of the floor.
No way I was selling the floor of this does not belong to the Three Guarantees is not a large area, then you are going to buy a bad floor put on the Hai Li fist box Yugu Feng Feng auxiliary order if 12 mm above the general blister no more than 40 hours generally no problem
