The previous set-top box was broken and changed again, but I don't know how to put the TV strip out. Did I use the previous set-top box remote control or the TV remote control to study? Who would like to tell me the operation procedure?. It's better to use -- ---- the next step.
If it is determined that the battery of the remote controller is insufficient, the signal strength of the remote controller that is less than the intensity required to learn is properly operated. The batteries of the two remote controls will be replaced with new resolutions.The set-top box remote control is a learning remote control. The remote control of the TV comes to the control area and the learning area. Each key (9) can learn any function (copy), the TV remote control button of your home.Specific learning methods can refer to the instructions of the built-in set-top box or the back of the remote controller.Built in set-top box instructions:User guide for operation via remote controlsMethod remote control menu button, set-top box:1 press the settings button on the set-top box remote control (about 3 seconds) until the blue light remote controller is on.2, click the button to learn (e.g. power), the blue light starts blinking, and when the remote control is learned, the receiving state.3, the TV remote controller and a set-top box remote relative (relative to the launch tube), hold down the TV remote learning the corresponding button for a few seconds, then the set-top box remote blue a few simple flash to the long bright state, it represents the main learning success.4, for learning other buttons, repeat steps 2 and 3.5, click the settings button, or 30 seconds without operation, the blue indicator does not light, which means that the operation is saved and exit from the learning state.Is it possible to fix your problem?
The set top box has instructions!First of all, press the "Settings" button, three seconds later, the indicator light in the long light; then, the TV remote control your alignment receiver learning your set-top box remote control, press the TV remote control on the "power" button, if you find the red light of learning your set-top box remote control this shows that flash, remote control has received signal; now, press the power button on your set-top box remote learning corresponding, the red indicator will blink again, this shows that learning your set-top box remote control has learned to switch the TV; the indicating lamp and a long bright state, we can carry on with other key learning. Learn the "TV/AV" button, volume plus, and key down in the key part of the TV in accordance with the above method. When all is finished, press the "set" button again to lock the code. The red indicator goes out, indicating that the key has been confirmed and can be used.
You need to connect the remote control of the set-top box with the remote control of the TV set before you can control the TV set. The remote general set-top box has the television area, said the remote controller with learning function, remote control, TV and docking can learn, you can use the remote docking set-top box and set-top box and TV control. General docking method is as follows:1 press the settings button of the set-top box remote control for about 2 seconds. Wait until the red light is long and then release the settings button. At this time the remote control is on standby.2, the infrared emitter TV remote controller and a set-top box remote controller, TV remote control, press the standby button, the set-top box remote indicator will flash, then press the set-top box remote learning area of the standby button, the indicating lamp will become constant light, said the top the box has completed the standby button TV remote learning;3, and then you can install the above method of operation, learning TV remote control on other keys, such as volume keys, channel keys, etc..4, all keys to learn successfully, press the set-top box remote control settings button, you can quit the learning state;5, then the user can use the set-top box remote control on the TV button to control the TV, such as press the standby button to enable the TV to enter the standby state, press the volume key to adjust the volume of the TV, etc..
