How can marble be renovated and polished? What tools do you need and pay attention to those steps?
Marble refurbishedThe stone surface is slightly scratched and can be treated with a mild refurbishment process. Such as the old wax first wax, and then use the 800 diamond chip mill grinding with clear water for ten minutes, note: the water in the grinding process, to keep the ground moist, and use water suction machine to prevent sewage from sewage, pollution of the ground second times. Then change to No. 1500 and No. 3000 polishing pads, diamond saw piece, using the method of grinding one by one. After the completion of the renovation process, clean with water and blot the water on the surface of the stone.
Ground cleaning maintenance: when the surface of the stone to form crystal mirror, use the vacuum cleaner to suck ground residue and water, and finally the use of polishing pad polishing, the surface is completely dry, bright as a mirror, if the local damage can be the local maintenance, construction completion can always walk on.
The whole ground maintenance treatment: if the porosity is large (stone sandstone, travertine marble etc.) to door besmear, after 12 hours, and then washing machine alternately to complete K2, K3 drops mill on the ground, K2-K3-K2-K3-K2 a total of five times, and then put on the white polishing pad, spray a small amount of K1 potion. RE polishing time, in order to increase the surface hardness of the ground.
Old marble renovation1. Clean the ground thoroughly. Clean it with dry and clean ground. No sand or impurities on the ground2, the whole stone surface cleaned, with marble glue to each stone above the small stone to repair the damaged point and raphe, the original stone with the color of marble near the glue to repair the damaged surface. Then use the slot machine dedicated to the original stone stone installation of the raphe re neatly cut slot, make the width of gap, and close to the stone color on the marble glue to fill (Note: if you've already done raphe processing is new open without seam). Such as dry glue can do the next procedure must be repaired after the marble glue.After 3, the marble glue drying, grinding the whole ground use grinding machine, overall horizontal grinding, grinding key caulking glue at the stone between (corner stone between) and close to the wall, decorative style, special shape at the edge of the ground to keep the whole stone flat, polished finish again, again marble glue caulking caulking complete continue second grinding, and stone retreading machine with steel mill stone tablets from coarse to fine, (150 mesh, 300 mesh, 500 mesh, 800 mesh, 1000 mesh, 1500 mesh and 2000 mesh), a total of seven times to complete the burnish surface overall smooth, then steel wire cotton polishing, polishing to achieve the design requirements of the degree of brightness (70 degrees), no obvious gaps between the stones
