How can the injection machine be set with parameters?
This problem is too big, ha haSpecific analysis of specific issues
4. check the cooling pipe for long distance flow, and the oil cooler and barrel end of the cooling water jacket into the cooling water.5. before the injection machine operation, check whether there is lubrication in each moving part, and add enough lubricating oil.6. turn on the heater and heat the barrel. When the temperature of each section meets the requirements, the insulation will be kept warm for a period of time to keep the machine temperature stable. Holding time varies according to the requirements of different equipment and plastic raw materials.7. add enough plastic to the hopper. According to the injection of different plastic requirements, some of the raw material is best to go through drying.8., the heat insulation cover on the cylinder can be covered, so that the electric energy can be saved, and the service life of the electric heating coil and the current contactor can be prolonged.Operation process1., not for convenience, and arbitrarily cancel the role of security doors.2. pay attention to observe the temperature of the pressure oil, the oil temperature should not exceed the prescribed range. The ideal working temperature of hydraulic oil should be kept between 45-50 degrees centigrade, which is suitable for the range of 35-60 centigrade.3. attention to adjust the travel switch, to avoid the machine in the action of impact.End-of-job1. after the injection molding machine operation is completed, the cylinder should be cleaned of plastic, to prevent residual oxidation or long-term thermal decomposition.2. should be open to the mold, the toggle mechanism is in the locked condition of time.3. workshop must be equipped with lifting equipment. When handling dies, care shall be taken to ensure safety in production.
Injection molding machine, also known as injection molding machine or injection machine. It is a thermoplastic or thermosetting plastic plastic molding mold made of plastic products of all shapes of the main molding equipment. It is divided into vertical, horizontal and all electric type. The injection molding machine heats the plastic, applying high pressure to the molten plastic to make it crack and fill the mold cavity.Operation points:Before booting1. before the injection machine operation, check the electrical control box whether there is water, oil enter, if the electric equipment is wet, don't turn on the machine. The maintenance personnel should dry the electrical parts and then turn on the machine.2. before the injection machine operation, check whether the supply voltage is consistent, generally should not exceed 6%.3. check emergency stop switch, front and rear safety door switch is normal. Verify whether the motor and the pump rotate in the same direction.
