Home > categories > Security & Protection > Smoke Detector > How do I reset a Bell 5-Digit 3.5ft by 20mm cable bike lock?
Question:

How do I reset a Bell 5-Digit 3.5ft by 20mm cable bike lock?

I just bought this bike lock hoping it will keep my bike in one place when I leave and I can't seem to reset it. The instructions are as follows:1. Set combo to pre-set 0-0-0-0-02. Remove locking pin from cylinder (this is where I am stuck, how?)3. Rotate reset mechanism to the right until it stops.4. Set your new 5-digit combo5. Rotate reset mechanism to the left.Please help, any advice or tips to open this thing would be much appreciated.

Answer:

It will keep on growing for another few years, so you should grow into that size condom. However you might just be using a condom to big for you, you can buy different sizes.
i think of you will possibly have problems with some, exceptionally on inner maximum estates, i'm effective they are financed via the replace exhaust companies. interior the early days one became so steep a artwork clleague in an MGB Midget, ended up like a see-observed on one. no longer sturdy in any respect.
Tiny power failures? It happened to ours as well, turns out the large battery they were connected to had died, they were all hard wired to the electrical panel but, also connected to a large battery near the panel, I'm assuming it is a backup in case of power failures. Once we disconnected the five year battery and replaced it, no more false alarms.
There is a possibility that you have aluminum wiring in your home. When aluminum wire is connected to copper it corrodes. Special connectors must be used. Another possibility is that you have had a wire slip out of the wire nut inside the junction box that the detector is connected to. You may have to check them all. A lose wire inside the main panel could also do this. This is a high voltage area, if you don't know what your doing do not remove this cover. If you do them check for lose connections and you will see if your home has aluminum wire by looking in this panel.

Share to: