How do LED lamp tube install how connection?
Leds that do not normally require special orders are mostly built with built-in power, which is directly available. Most can only need to remove the starter on the traditional stent line (is a cylinder bracket highlighted below) mount tubes can be used, if not yet so could you use the stent is a relatively new "electronic" will be a little trouble need you open the stents to get inside the ballast also take off to the inside of the line directly connected to the utility, LED bulb is directly at the mains. Of course, if you understand the circuit and you're not afraid of trouble, it's advisable to remove the "regenerator", because the "ballast" is a power drain.
If it is a built-in power supply, you need to remove the ballast from the original stents and install them directly.
1: leds are built in, so you don't have to install them directly. 2: the LED tube is an external power source, and the original (electronic or iron core) ballast is removed and replaced by an LED power supply that can be attached to the LED lamp. 3: you also need to pay attention to the LED lamp is double side into electricity or single-ended into electricity, double side into power two ends electricity across the electrodes (note) single-ended into electricity is a head into the electricity but also need to pay attention to is the cathode
If you have a regenerator, you can simply unplug the LED, and if you don't have a regenerator, you need to remove the electronic ballast, which is a hassle
