How do you attach tiles with a laser level?
On the wall by a horizontal line, playing on the line, according to tile line.
Laser level is only used to measure the height of the skew.
The role of infrared level instrument is mainly to do mark high wire, to determine the level of tile or floor surface paving.From the 50 cm position, horizontal line play using infrared level, play a circle line as the elevation line, the ground floor tile or floor height of the surface layer and the elevation line to reach the same height, paving the face layer level.Before use, should first check whether the dial indicator in a controlled range, to avoid the measurement error caused by the inaccurate level zero, therefore before use on the level of the zero check or adjust to. Level zero calibration method: the horizontal instrument is placed on the base of the stable and approximately horizontal plate (or machine tool guide rail). When the bubble is stable, the end is read at the end, such as the left end, and zero. Then turn the level of 180 degrees, still placed in the original position of the plate, to be stable after the bubble, still in the original one (left) readings A, the level of zero error is two points A grid. If the zero error exceeds the permissible range, then adjust the level zero adjusting mechanism (adjustment screw or nut, the error is reduced to zero within the allowable value. The nut shall not be turned freely for the screws which are not specified. Adjust the level of working surface and the plate must be torn wipe clean. The adjusting screw or nut must be tight
