When the laser level is opened horizontally, it does not move on one line when it moves around. How can it be corrected?
The laser level adjustment in the horizontal center position, must take the center point adjustment in the center position, the more accurate and better. Don't think that we didn't ring eccentric alarm at certain position in the center, in fact is not necessarily is the center, but at a distance shorter than not more than 10 meters outside the basic can be a one-time success. The largest error is not more than 3 mm. When the flat side of the distance is beyond the scope of the provisions of the level; if the adjustment center at this time is not accurate so you need to first level line type as the base line to end then extended or moving position and the direction of the words: it is certainly to the connection is not at the same level error is large, so the level of the line side must not!
Move the instrument around? If so, it is because of the uneven terrain, the height adjustment can be.If it's spinning around, that's the instrument itself. Need to be calibrated or repaired.
Must move each other in the same line or in the same direction of the problem does not exist in the process of operating in a flat. Any position can continue operating grass flat or end of the last connection. When the need to continue the line; because of the rugged terrain to move not level position after the last level with the horizontal line, so the level of the level in no more than the level bracket (leg) range of height adjustment within the basic can be used to adjust the height of the solution. The correction method is in the three leg of the supporting frame on the two inner screw twist height adjustment, positive rotation is tightened and fixed, reversal is loosen adjustment, according to the specific needs for correction. If the level difference is beyond the scope of adjusting the height position, you should consider the high or lower level pad.
