How do you change the lights in the house?
Let one of the root drive power cord wrapped around the lamp power cord (chaozhou both positive and negative), on the one of tie up good, good electrical tape, another root connection same good tangle on electrical tape. Next, turn on the lights and turn on the lights. If you don't, repeat these steps.
Now turn off the lights switch (for safety) had better be to turn off the total power supply, and then into the drive power line (also can be directly cut short), then remove the bad driver And then put the new drive power input skin, two light thread dial the skin.
Turn off the power and slowly button down the lamp, notice the spring card on the lamp, and then press down the lamp with your finger. Then unwrapped connection head first, change the lamp holder, drive, open the lamp switch if the light is not bright is drive failure can be determined, replace the drive
