How do you put the water in the storage electric water heater?
Turn off the water inlet, turn on the hot water outlet, release the air, open the safety valve and drain the water,.......In fact, with the safety valve drainage speed is very slow, it is best to unscrew the safety valve.Furthermore, the hot water outlet is generally lower than the safety valve, safety valve under the action of gravity to the water, the hot water outlet to breath the water tube hot water in the hot water pipe blowing off without the gravity of water, water safety valve.Remember: the entire process must be unplugged!
The best look at the instructions, stating the outfall where, very simple, there is a small baffle, down saw inside screw, with a wrench screw can squeeze down sewage, sewage after re water also should pay attention to open the lemon head, otherwise the water can not be put in.Normally, the sewage is discharged twice a year. Replace the magnesium bar.
The water inlet pipe does not contain valves, and the water in the water heater is never clear. Long term use of electric water heater to discharge, the general water heater below the left has a special sewage outfall, remove the baffle, wrench with the sewage outlet screw down, you can discharge, drainage, sewage is not clear.
The first water inlet valve should be installed in front of a closed valve vent pipe, to drain the water in the water heater, first put on the water inlet pipe valve closed, then the discharge valve on the pressure straightening small handle, water hose down the emptying of the pressure relief valve.
