How is the EDUP2930 repeater relay mode set up?
First, insert the product on the socket, and the power indicator light shows the normal operation;2, with a laptop computer search and connect the wavlink-repeater signal repeater (repeater and notebook computer or can be directly connected with the cable) (Note: if unable to connect the computer to the IP instead of manual input: 192.168.10.2, after determining the third step);
In addition, consider the following installation techniques:1. install the relay first in a very good signal position. In order for repeaters to work properly, doing so can greatly reduce the problem.2. upgrade the firmware of the repeater. Before the installation process, check that your repeater has the latest firmware version.3. configure the IP address. Make sure that the address of the repeater is unique and that it belongs to the IP address range that the wireless network connection can confirm. In most cases, the default IP address can be used, but you need to check the existing access point to confirm it.4. configure SSID. To set it exactly the same as the SSID on the existing network. If this step is not made, the repeater will never work unless the repeater fails, and it automatically scans the neighboring access points, automatically configuring this configuration for the user.5. configure radio frequency channels. The user needs to set up radio frequency on the repeater so that it matches the settings on the existing access point. This is similar to that of SSID. If the channel is set differently from the access point, the repeater will not work properly.
After the signal that connects the repeater is entered in the browser address bar: 192.168.10.1 enters the setup interface;4, enter the user name and password are admin, login successful, select relay mode, to the next step;5, select the name of the router that you need to connect to, and change the name of the repeater to the name you can easily remember;6, enter the original router password, click OK, that is set successfully
