I'm doing an experiment to see if I can replace any of those material with cotton
in the event that they have been beginning to shrivel or dimple, it may purely be that the humidity develop into too low interior the incubator and the eggs have been dehydrating. in case you notice an egg beginning to dimple and capture it in time, you could save it purely via increasing the humidity. that's going to plump up and sense supple back. what's the temperature and humidity on your incubator ideal suited now? you go with the temp to be low to mid 80s. something above ninety can kill coming up embryos. Humidity could be between 70-one hundred%.
hi lizard 101, The vermiculite should be mixed with water at a rate of 4 parts vermiculite to 1 part water. The container will also need a lid with air holes. bearded dragon eggs should be incubated 84 degree plus or min 2 or 3 degree. sustained temperature above 90 degree can quickly kill developing embryos. incubation time will vary depending on a number of facts including but not limited to Temperature and humidity. typically bearded dragon eggs will take between 50 80 days to hatch, with 2 months being average. hope that helps to you. want more information search our sites: Thank you
If they reached a temperature of 91.5 it may have killed the embryos. also there is a possibility that they are too moist. rule of thumb is that when preparing vermiculite of perlite you should add water until the mixture clumps, but nothing drips out if you squeeze it. If you think there are good eggs left, physically separate them from the moldy ones and check your incubation substrate to make sure its not too wet. The eggs take 65- 75 days to hatch.
