Stainless steel bowl bottom tear to a trademark stickers printed at the bottom, with a lot of ways to use!
Pour some wind in the offset printing, such as a cloth to wipe again after a minute or two, I have no trace at all
Use hair dryer blowing on trademark, blowing from the bottom side edge tear is ok, because the blower is hot, you can blow dry offset printing of trademark.
Clearly the answers above is not too good, I cleaned the stickers of punching, steel ball can't wash clean, the adhesive had better use dry towel or cloth to rub repeatedly, the friction heat the glue will naturally follow the paper towel or cloth,. , and very clean! You might as well try it my way, I met such a situation is such processing of ~ 1
The most effective, with day take water glue dreads the day with water
