TV resolution is too low, looking at the eyes hurt, the computer did not network, solid egg pain want to use the set-top box to connect the computer, Google search for no fruit, all advertising, seeking people! More
. if the computer monitor with HDMI interface, directly with the HDMI cable from the set-top box HDMI port to connect the HDMI interface can be displayed. . if the monitor does not have HDMI interface, only HDMI to VGA or DVI converter (to have audio output interface), the video directly connected to the monitor, the audio needs to use a one end is 3.5mm plug connector and converter On the audio output port connection, the other end access to a speaker can be. . if the monitor also connected to the computer to use, that only select a TV with more than one HDMI interface. Otherwise, only often plug the cable.
. desktop computer installed before the preparation: tool preparation: needle nose pliers, heat paste, cross knife, flat mouth knife and so on. Material preparation: CPU, motherboard, memory, graphics, hard drives, floppy drive, CD-ROM drive, chassis power, keyboard and mouse, monitors, a variety of data lines / power lines. . disassemble the order and installation sequence: off power - split cable (all connected with the motherboard) - remove the motherboard on the expansion card (discrete graphics, independent sound card, network card, TV card, etc.) Demolition of the motherboard on the memory, CPU - demolition drive hard drive power. Installed in the order of the contrary. . the power of the line up to take the main line is the main power supply output line, from the other side of the chassis wiring, according to the location of the device to set the length of the line, from the hardware power supply interface is just below the corresponding power cord connected. The purpose is that there is no clutter in the chassis of excess lines, affecting the appearance and heat. Chassis switch and audio and built-in USB cable, but also the principle of wiring.
Absolutely, the analog signal will produce a different degree of interference, unless it is fixed, but the digital signal is not disturbed, if your line is not very long (one meter or less ), This interference is negligible.
You said the installed capacity, is to install the computer hardware bar Install the order is the first CPU and heat sink and memory, install the motherboard, and then install the motherboard to the chassis, the screws fixed, and then install the hard drive, video card, power supply. PC power line up to take a good line is the main power supply output line, from the other side of the chassis wiring, according to the location of the device to set the length of the line, from the hardware power interface is just below the corresponding power cord connected. The purpose is that there is no clutter in the chassis of excess lines, affecting the appearance and heat. Chassis switch and audio and built-in USB cable, but also the principle of wiring. I wish you installed well!
