How to install satellite receiver household?
First introduce the household satellite antenna pot, which have accessories:1. satellite receiver.2 nine Ku head.3. satellite pan.4 coaxial cable (wire).Installation and debugging is simple, divided into four steps:The first step, the satellite TV receiver and two small joint end connected to the line, then plugged in, or how is not successful.The second step, remote control, there is a "information" (some of the stars) key? Click on the signal quality and signal strength of the indicator bar, in which the strength of the line is clear, the quality of the alignment, pointing to the precise situation of the satellite.The third step to adjust the pot; adjust the angle of elevation and azimuth angle of the pot. (generally only need about regulation)Adjust the azimuth and elevation angle of pan (South West film at the beginning of a more accurate range), is not the same place, angle is not the same, at the beginning of a good adjustment after the power and turn on the TV receiver, the television set to AV (video) state.
To use the TV set next to the slow, fine-tuning, pointing direction, there is a signal to stop, you can
If the quality of the signal does not go up, check it out:The 1 tuner polarization direction is correct, ensure that North Korea is at the top of the 0 scale.2, the angle of elevation should be approximately 15 degrees behind the vertical.3 horizontal directions should be maintained at about 43 degrees, South West direction.4, the pot in front of no obstacle.
Under normal circumstances are in place to buy to try a good fixed angle, back is mainly transferred to aim at the satellite direction, do not adjust the angle and position of the satellite is mostly South west. Signal strength is more than 60, do not need to tune it, the most important thing is to adjust the quality of the signal.Put the pot on a closed space, front 4 meters without large shelter (too fat), in the South Western pot receiver move slowly, generally the best 2 individuals, a small move, a look at the quality of TV signal. Believe that soon will fix. To move slowly, be patient, because its signal quality is easy to move, it is easy to change, the best good quality is also transferred to more than 60, so that you can receive about 40 taiwan. And tell you a trick, one can also adjust the signal quality: the satellite satellite receiver pan and get together with the roof to debug, satellite receiver if there is signal it will display red or green, how no signal lights have been not bright. It's the red dot (or green light) in front of the program P00, and the signal is on. Basically half an hour, and received 43 units.The fourth step. The last step is fixed, there are professional fixed, but simple to take a few bricks, head pressure on it.The problem is not to receive signals to occur frequently, we can do: put pot set a height, slow rotation around a circle to see whether there is a signal, if not, just set a new height in rotating around a circle, always pay attention to quality of signal has not exceeded 0, so the cycle. Must be able to find the signal. PS: don't worry. If you set it up, you don't have to move it. Once and for all.
Household satellite antenna with the lowest cost, the fastest speed, the most effective way, the rapid spread in the vast rural areas, rural friends get approval. But many people do not install, then talk about how to install household satellite antenna.Installation equipment:1 assembly and installation of the antenna tuner: the antenna tuner and in accordance with the instructions to connect (pot to help sellers according to the good, including elevation).2. wire: connect the wire on the set-top box to the line on the tv.3 adjust the antenna elevation and azimuth elevation scale is: preparatory work in front of the query antenna elevation angle -22 degrees, such as antenna calibration have been corrected by the query to the offset angle angle; azimuth: South west.Set parameters:1, press the "menu" button on the remote control, enter the "main menu" interface, select "system settings"".2, enter the password "9999".3, in the "system settings" interface, select "installation and signal detection" (the default has been selected), press the remote control "confirmation" button two times. Standing in the back of the satellite antenna, satellite antenna for the positive from south to slowly turn the direction of the satellite (suggested that the rotational speed is slower than the speed of the second hand watch). In the process of turning to stare at the TV satellite receiver debugging interface signal strength and signal quality change indication signal turns green when stop action, that has been locked and identify the satellite satellite signal.
