Home > categories > Electrical Equipment & Supplies > Cable Ties > How to install the elevator installation monitoring! The
Question:

How to install the elevator installation monitoring! The

The elevator has 23 floors. But I have not installed before. I would like to ask how to install. How does the video line go? Thank you more

Answer:

Wire selection of the best, the best use of elevator dedicated line or 8 minutes signal line, many people think that the reason why the main purpose of this wire is anti-interference, in fact, there is an important reason is that the wire often in motion, What is the core? The installation of dedicated elevator cameras often have openings, a lot of people are very difficult things Oh, and some high-end elevator openings are not good, the material is very hard, and often there are several layers of material, the hole size to master, small We can expand, big on the trouble; pay attention to anti-interference. When the elevator starts, the surge is very scary. And the camera is not much relationship, and your construction level and the relationship between the wire; installation time and the elevator workers must be, this is still more dangerous. Not only the construction workers are dangerous, there may be endangering others. There was a building in the elevator monitoring, elevator workers to stop the elevator, the construction staff in the work, but do not know why, the top of the elevator door opened, there is a buddy did not see, directly into the elevator inside, Empty; with the cable that deal with the best, and the old elevator more exchanges about. Remember not to take the elevator from the top of the elevator overhaul the power supply, infuriated infinity. Do not waste the wire bar. There is a small skill of negotiation. Elevator inside the monitoring is difficult to effect, and must be clear in advance and Party A, do not let Party have a high expectations, this small area of ??the screen feeling certainly no outdoor large area of ??the effect of space to be faster.
Must be looking for maintenance elevators are under the staff communication, because we are not on the elevator car roof are right. Let them cooperate. And then to the top of the elevator to make a hole on it. Elevator top 220 power supply! It is best not to take, the elevator power failure will be invalid, how to see someone in the elevator did not. Signal line extension of this cable with cable tie, must be shielded, there are lifts are dedicated. Ordinary signal lines can also be used with soft!
You can find the staff responsible for the maintenance of the elevator with the shaft of the line with the cable can be wrapped together, but to have shielded wire.
Contact the elevator manufacturers with a few holes in the top of the elevator to fix the camera, the top of the elevator can be powered, the video line elevator manufacturers are equipped with a dedicated, it is the kind of soft can move up and down with the elevator, Go on the line, you need to pull from the monitoring room to the elevator room to receive its video line on the line.

Share to: