Home > categories > Automotive & Motorcycle > Wheels > How to make a 3 wheeled go kart?
Question:

How to make a 3 wheeled go kart?

Can someone tell me how I can make a 3 wheeled go kart using a lawn mower or scorer engine.

Answer:

The Altima's have had issues with the brake master cylinder leaking brake fluid into the brake booster causing the fluid level to be low and turning on the VCD and Slip lights. Check your brake fluid level. If it is low, top it off and drive it to see if the lights come back on. Also take it to your Nissan dealer and have them look at it as soon as posible. A weak battery can also cause these lights to come on.
This Site Might Help You. RE: I have a nissan altima with a (vdc off-light on at times at the same the slip light comes on also)? both lights come on at the same when the car is moving ( VDC_OFF AND THE SLIP LIGHT ON ) if u park the car start it up all lights in dash r out go down the road about a mile and the lights come on ,owners manual sayes a little about it but not enough 2 troubleshoot it , the tires are getting low.
Hi , I have Nissan Armada, as you all I have the same vdc off slip brake Error, (it came when changed the break bads, and due to this the 4x4 couldn t work , I tried every thing but this error stays , I took them to Nissan dealers but even they are unable to find the cause only computer show communication error , on internet there is no solution found yet, Nissan is very unserious to solve this issue , But 1 thing is sure , I am never again going to buy any japnies car again
build the frame, attach wheels, attach seat, use engine to power the rear wheels, use front wheel to steer. if you want more stable system, use two wheels in front and one in back. this thing can take some crazy turns without rolling over. ideally you would put the engine in front to drive both front wheels and use the front wheels to steer but this is kinda complicated.

Share to: