I have a 93 lumina 3.1 fwd. The transmission went out on it so i installed one out of a wrecked car. got it all hooked up. started and it started leaking heavily fron the drivers side axle. how do i replace the seal? I got a trans in there but im not that smart when it comes to transmissions so a step by step with do and donts would be appreciated, thanks much
First be sure the axle is seated properly (all the way in the socket). If it is, you have a bad seal. Remove the axle and pry out the old seal. Evenly tap (to avoid distortion) the new seal in place, then replace the axle.
some alarms have a hidden shut off/reset switch usually hidden under the dash.
Disconnect the alarm from its power source, then try starting the car.
