Home > categories > Electrical Equipment & Supplies > Pressure Switches > I would like to use a two-point output pressure switch to achieve high pressure stop pump,
Question:

I would like to use a two-point output pressure switch to achieve high pressure stop pump,

I would like to use a two-point output pressure switch to achieve high pressure stop pump, low pressure pump, I would like to ask how the line should be connected, the best wiring diagram, thank you.

Answer:

This is very simple. Low pressure when the node connected, then you through the middle of the relay often open the point to lock the node,
to a high point, through the other relay off the pump on the line The
so that even if the pressure will not stop the high point of the pump;

Share to: