In the design of the two speed reducer, the diameter of the motor shaft is 42. The minimum allowable diameter of the gear shaft is 20. What type of coupling can be selected?
5 motion and dynamic parameters calculation of transmission device 55.1 calculation of shaft speed 55.2 calculation of shaft power 55.3 torque calculation of each shaft 56 design and calculation of drive parts 5
9.2 selection of output shaft couplings 12Selection and calculation of 10 key links 1210.1 selection of key joint between high speed shaft and intermediate shaft 1210.2 selection and calculation of key joint on low speed shaft 1211 lubrication method, lubricant grade and sealing device selection 1311.1 lubrication method 1311.2 lubricating oil number 1311.3 sealing device 1312 other technical instructions 13
Catalog1 Introduction 32 design task book 33 Analysis and formulation of transmission scheme (attached transmission schematic) 44 motor selection 44.1 motor power selection 44.2 motor speed selection 44.3 total transmission ratio calculation and distribution at all levels of transmission ratio 5
