Today I spent 100 yuan for a pair of xenon bulbs (do not know is really fake), I was the Great Wall C30 original headlamp bulb is 60 / 55W replaced 360 / 280W xenon headlamp bulb, without any modification Add a pair of light bulbs, I would like to ask this car line and lamp bowl in the end there is no impact ah, I asked the master of the lamp that no problem. Please understand the master and give advice and suggestions. Thank you first. I will not change the original.
How can there be a non-fortified hernia lamp ah was cheated it, there are watts higher than the original car after the line will be aging faster, generally nothing, do not worry, little impact! There are hernia bulbs are generally 35 watts or 55 watts, and then a big line on the aging fast! The cheapest hernia light set seems to have 2,3 100 ah, not so cheap it!
Ordinary car light bulb maximum power is 100W, if the original 60W light bulb into 100W, then the feeling is bright, but the high-power bulb heat is also large, after a period of time will make the reflective surface yellow, thereby reducing the reflective efficiency, The brightness of the headlamps has been reduced. Another high-power bulb operating current is also a lot of big, easy to cause the socket connector burned, as well as the risk of fire. So do not blindly replace the high-power light bulbs.
First tell you that there is no 360 / 280W xenon headlamps on the car, xenon headlamps generally around 35W. From the appearance of xenon bulbs and ordinary light bulbs are completely different, xenon bulbs without filament, and ordinary light bulbs have filaments. From the working principle, the two are also completely different, xenon lamp is generated by the discharge between the electrodes and produce arc, so it needs to rely on the booster to increase the voltage in order to make the electrode breakdown between the discharge, after the start of discharge Live current is not too large to complete this task is commonly known as "ballast" stuff. The ordinary light bulb is by direct current heating filament, so that the temperature rise to red, so as to light, so it does not need "ballast" like auxiliary facilities, direct power on the line.
