Installation method of buried lamp
In addition to the installation of common sense and skills, a high quality hardware device performance (such as light source, full sealing, etc.) can also greatly simplify its installation process, to achieve twice the result with half the effort. In fact, LVD underground lights should be a good choice. It is made of high quality aluminum alloy. It is beautiful and durable, and it is resistant to hot and cold and toughened glass. In the waterproof and dustproof performance, high temperature silicone rubber ring. When installing, all stainless steel screws are used to make it safe and beautiful. In addition, equipped with LVD Venus electrodeless lamp, with high luminous efficiency, long life, good color rendering, light stability, no flicker, energy saving, wide color temperature range, light light, light output stability and so on. After the introduction of the relevant skills and hardware knowledge, I believe that the installation of buried lights should be further understanding.
First of all, in the installation or maintenance of buried lights, should ensure that the power cut off in order to operate. And in the bottom and around the lamp must be laid broken stone and sand, so that it can facilitate drainage and heat dissipation. For its surrounding environment requirements, it is better to non corrosive, flammable and explosive media exist. Note, here to introduce the more important two installation skills: the introduction of line through a coil into the lamp, tighten a coil to prevent rainwater by introducing the line into the lamp body, causing damage to electrical appliances; covering the buried lamp glass, light source should be 30 minutes or so, so in the process of using the lamp, the glass will not have water.
Ensure the ground lamp (including underground lamp quality and embedded parts) in underground lamp installation should be mainly about three problems:1, the wiring seal should be done well;Our general wiring buried lights in the special sealing rubber ring and stainless steel fasteners, the wire (in particular, please use the three line wire cable) through the rubber ring, stainless steel wire and then tighten to the firmware can't pull out the sealing rubber ring2, the construction of groundwater should be done to infiltrate, can not let it bubble in the water (because it is not underwater lamp);3, in the buried lamp installed, open the cover, light points for half an hour on the back cover (this step is very important).
