Installation method of Volkswagen New Bright cushion
Inspection prior to installation.1, when the car cushion is ready to install, please check the quality of the car seat cushion and strong suture, whether or not the length of the right or not?.2, now the general car cushion is usually five pieces, the front drive seat is conjoined two, the back seat is two single back and a big pad.
As cushion is a universal design, to solve the flexibility of many types of vehicles in the form of elastic, because it is not customized by vehicle type, so the effect and installation method of each model is not exactly the same. According to the installation experience, if the model is more special, although not completely normal installation, but the normal use of basic no problem.
Rear seat cushion installation.(1) before installation, please observe the installation of the rear seat. There are two kinds of back seat, one is buckle type, and one is without buckle type.Buckle type automobile seatA car seat without buttons(2) the seat that does not have buckle type can pull out long seat forcibly directly, the long chair that has lock, press lock catch, pull out long seat again. Some seats are screwed with the car body, and then the screws have to be taken apart. Separate the long seat from the rear.(3) after separating the seat and the back of the cushion, the cushion passes through the bayonet on the cushion of the car and is fixed with a long cushion. This can also be set back into the back seat on the cap.(4) finally, after the long seat is installed, be careful that the seat belt should be reset. Then, insert the cushion of the car seat, the cushion of the back and the back of the back into the slot, and then flatten the cushion of the car.(5) the rear row head, pillow and seat of some cars are conjoined, and can be directly sheathed.
Mounting of front seat cushion.Car seat cushion cap before driving general hood, can be directly to the car seat to set good, and then in the car seat in the connecting point of one or two buckle, can put the car seat buckle seat is inserted into the gap by hand, let the car seat does not move forward. The front of the car seat paved and two small ring hook into the seat below the iron bar.Some small but no tongue with elastic belt buckle, then take the snap through gaps in the middle seat through one head buckle and from under the seat and through the other end of the buckle lock. In this way, the front row seats are installed.
