Instructions for the use of cycloidal pinwheel reducer
6, the factory's reducer has been added grease, replaced every six months. Grease uses two aluminium sulfide -2# or 2L-2# lithium base grease. In 1, the output shaft is additionally arranged on the cycloid reducer coupling, using direct method does not allow thump pulley, sprocket and other links, because the structure cannot output the speed reducer shaft axial force of the shaft end of the screw thump, available screws press connectors.2, the output shaft and input shaft diameter, select GB1568-79 matching.3 、 the swing rings on the reducer are only used for lifting reducer.4, on the basis of the installation of speed reducer, should be calibrated reducer installation center line elevation, level and related parts of the relevant size. The concentricity of the calibrated shaft shall not exceed the allowable range of the coupling.5, speed reducer on time, can be made of steel pad or cast iron pad block, cushion block in the height of not more than three pieces, also can use the contract iron, but after the reducer calibration should change into the flat pad block.
1. The cycloidal pinwheel reducer is allowed to be used in the continuous working system, while allowing the positive and negative directions to operate in two directions. Some types of cycloidal pinwheel reducer are only allowed to rotate in one direction.2, the input shaft speed, rated speed of 1500 rpm / min, in the input power of greater than 18.5 kilowatts, it is recommended to use 960 RPM / 6 pole motor matching.3 、 horizontal installation cycloid pin gear reducer working position is horizontal position. At installation, the maximum horizontal inclination is generally less than 15 degrees. In excess of 15 degrees, other measures should be adopted to ensure adequate lubrication and prevent oil leakage.
In general, 2 cycloid reducer using 40# or 50# mechanical oil lubrication at room temperature, in order to improve the performance of reducer and prolong the service life of the cycloid reducer, recommended 70# or 90# gear oil, working in high temperature and low temperature conditions can also be reconsidered in lubricating oil.3, vertical installation of planetary cycloid gear reducer, to prevent oil pump broken, in order to avoid the parts of the reducer damage.4, when refueling, you can spin the upper seat of the breather cap, you can refuel. When oil is released, the oil drain plug at the bottom of the rotating seat can release the dirty oil. When the decelerator leaves the factory, there is no lubricating oil inside.5, the first time on 100 hours of operation should be replaced with new oil (and internal oil rinse) after continuous work, the replacement once every half a year (8 hours), if the poor working conditions may be appropriate to shorten the time of oil, proved the reducer for frequent cleaning and oil (3-6 months) have plays an important role in prolonging the life of gear reducer. In the use of lubricant should be often added.
