Hi,I'm trying to connect a Panasonic CQ RDP200-LEN car radio. Normally,there is red and yellow wire for ignition and constant,and a black wire for ground. However,this unit has 2 yellow wires,2 black wires and a red. Where do these wires go? thanks
I know waht you talking about for the wiring. my dual deck was the same way as far as the average wiring you were talking about..... that does sound weird. the other wires might just be for xtra hook ups that u dnt have. however dont take my word for that! what i would do is looking up the wiring diagram for the exact model that you have, look at the manual that came with it if there was one, or call a number for the wiring on the deck if there is one.
Honest answer is to take it to a audio specialist. finding and wiring a stereo from scratch (termed hardwiring) is a hard job even for the most advanced audio specialist. This is speaking from experience. Most wires are not colour coded and you will need a amp meter to measure the current, voltage, continuity and resistance in order to find out what wire does what. One wrong wire could mean new speakers or in the worst case set fire to your car. I've have done hardwires for over 5 years, and I've seen some real mess, which quite possibly could have been avoided for a few quid but impatience and inexperience has lead to new cables, trim and other pieces which were damaged due to bad installations. Please be careful!! added 9/11/06: (Note To other answeres) Don't use Choc connections or block connectors for wiring stereos as these are open connections with exposed areas of metal if they came into contact with earthed chassis they can cause a short try using bullet style or butt connectors they are more secure and sheilded!
