I am a furniture factory, need a lot, it is best to paint to dry is the best, the ash inside the shop, if the dry time is too slow for local repair will be dust, it will look at the dust, affect the quality of the product.
Is the seal broken? Paint and paint is not the same, to go inside with the infiltration density board paint, fill the effect is not good, to what the people network to find a professional furniture repair.
Just with the paint, after the repair is finished, wipe with banana water, and it will be beautiful after natural drying.
Or engage in equipment, see what reason end edge after the show mainly has several aspects, one is only one side of the saw, if it is open at the end, you saw the small saw blade is too high, it low, or with a pre wash milling is good, if the two sides open at the end, it is too big to glue look, what reason, if it is winter, due to low environmental temperature, glue just painted on the solidification, the pressure is not real, for glue, stick firmly, installing plate preheating device can solve the problem, the problem is not winter, edge glue painted edgeband sub pressure wheel pressure is not enough no, pressure, or your gum is not good quality, short solidification time, low temperature may also glue you to adjust, will cause this situation. If your edgeband side open at the end, it is your problem finishing knife adjustment, adjustment is too large, it is good to adjust
