Pvc soft glass plate how to cut
Laser or engraving machine, if only cut into a square can also be mobile phone cutting
That is, PVC transparent board, you can use woodworking table saw or engraving machine processing
Cutting 5-6mm thick glass method is, in addition to the application of different ruler, but also in the cutting edge of the pre-brush on the kerosene, the glass after the kerosene will be cut into the knife-edge, it will be easy to pull off. Cut large pieces of glass, because the glass area is large, people standing on the ground can not operate, so the operator needs to take off the shoes on the glass surface to cut, so in the glass below (that is, the table must be a layer of velvet So that the glass even pressure. Cut off the glass when the two sides of the glass to hold the end of the glass, and the other end of the glass using the weight or uniform pressure of a certain weight, through the edge of the case, his hands down the uniform force off, Causing the rupture of the whole piece of glass.
According to different thickness of the glass application of different specifications of the ruler; such as cutting 2-3mm thick glass, available 12mmXl2mm thin strip of wood ruler; cutting 4-6mm thick glass, available 4mmX 50mm wood ruler; cutting width 8- 12mm glass, the need to use 5mm X30mm wood ruler; sometimes according to the operator's habit of using ruler. The specific cutting when the use of wood or steel tape measure the size of the glass frame, and then cut on the ruler size; to consider leaving 3mm gap and 2mm knife edge. Such as cutting 2-3mm thick glass can be on the ruler of the small nail close to the side of the glass, glass knife against the other end of the ruler, one hand by holding a small nail to withstand the glass edge does not make it loose, the other hand Grasp the cutting edge straight cut, can not have the severity and bending phenomenon.
