Solid wood particle board and MDF wardrobe, which is better?
Solid wood particle boardAn artificial board made of wood or other lignocellulosic material, applied with adhesive, and synthesized under the action of heat and pressure. The principle is the same as the density board.Advantages: 1) solid wood particle board for the intersection of scattered structures of granular. Therefore, the nail holding power is good, you can nail round nails, screws. The machinability is superior to the density board.2) solid wood particle board density is higher, the wood fiber particles in the board are larger, more retain the nature of natural wood, in the use of adhesive, the solid wood particle board content is generally less than 5%, environmental protection is better.
Is MDF MDF, it is wood fiber or other plant fiber as raw material, after the break, fiber separation, drying after applying urea formaldehyde resin or other suitable adhesive, a man-made sheet made by hot pressing.Advantages: fine material quality, cutting edge seal is good, not easy to open. Easy to squeeze into a variety of shapes, easy to do modeling, so usually do more door panels or backplane.Disadvantages: because the substrate is powder based material, the use of glue more than the particle board, more prone to environmental problems. Secondly, the content of MDF glue, the internal structure of the space is little, moisture resistance is poor, put a piece of density for 24 hours in the water, more than ten hours later it was obvious tilt up four density board, deformation.
The solid wood particle board has small warpage, good dimensional stability, high strength and good stiffness, and it is not easy to press heavy clothes. At present, the artificial board used in European furniture market is mainly made of solid wood particle board.Disadvantages: solid wood particle board evenness is inferior to density board, make radian and modelling are more difficult
