Stainless steel plastic film for more than a year, how to remove clean? There is also a layer of plastic film after tearing off how to remove?
In practice, we found the following two good methods: alcohol to eliminate division. With a soft cloth dipped in sufficient amount of 95% alcohol, and then gently wipe the self-adhesive place, self-adhesive will easily become soft and divorced, while alcohol generally does not damage the plastic parts or painted surface. But sometimes find some alcohol on the sticker is not very effective, this is use a soft cloth dipped in a little gasoline graze attention stickers, because of a plastic or gasoline paint has dissolved, so be careful to use either first in an important place of light clean look, if there is no problem use; but must be careful not to use too much fuel, at the same time should be short! I have tried to wipe the surface of the car with gasoline for a short time. It has no obvious effect on the surface of the car body. As a result, it's easy to remove the glue......
Give you some ways:Driving friends are in contact with the car stickers, such as many small ornaments, marriage tie with float transparent protective film, some parts of the certificate and so on, after the removal of these things, often leaving hard to remove traces of adhesive in the car or the car surface, don't fall, and not hard to scratch. What shall I do?
The newly bought stainless steel pots or glass stick on some labels, off the labels, stickers on the traces of it is difficult to remove, wipe with a damp cloth, scraping knife will often leave traces, after repeated practice, I summarized some tips to share with you.On the hard surface of the self-adhesive mark, we can use non greasy wash water on the surface of the object, and then gently wipe with soft cloth; with industrial alcohol or gasoline can also remove these traces. If these stickers are found on the skin, they can also be removed with lemon juice.
Buy a bottle of glue is only a few 20 dollars, a lot of places can use. Also can use for a long timePut some decorations on the front door with strong adhesive tape, and then leave a mark of glue on the door. Use gasoline or kerosene can erase the tape, buy 1200 water sandpaper to wipe water speckle trace, buy a pot of transparent varnish, banana oil to dilute, brush brush once a response to light. Do not use nail polish brush to wipe, can go to the gum stains, but the door will become a misty white spot.Protective film: first, scrape the protective film with a knife, then wipe it with petroleum essence; the frosted glass will wipe off the protective film and then wipe it with turpentine.
