Technical requirements for protective gloves
Leather protective glovesUse chrome tanned finished leatherThe surface of the glove without cuts, abrasions, insect injury and incomplete phenomenonThe thickness of the gloves monolayer is not less than 0.8mmThe chrome content of gloves should be no less than 3.5%Leather gloves are not allowed to be covered by masking defectsIt does not allow the use of compounds that stimulate the skin leather processing gloves
White yarn protective glovesWhite yarn gloves is divided into flat and rib two.Higuchi Shirasa gloves should be made of white coarse cotton (21 * 8) roots woven together with a weight of not less than 45g/ pairs.Rib white yarn gloves to use the coarse white cotton yarn (21 x 9) and made the weight is not less than 52g/.
Canvas protective glovesCanvas gloves are divided into five fingers, three fingers and two fingers, three kinds. Sewing stitch per cm 4-5 needle, canvas quality is not less than 380g/m -.
1, plastic (PVC) protective glovesThe gloves should be made of raw materials that do not cause skin irritation or irritation. The thickness of the gloves is not less than 0.6mm and the air is not allowed to leak.2 latex protective glovesSuch gloves are not allowed to leak, there is no obvious surface cracks, bubbles, impurities and other defects.3 rubber protective glovesThese gloves cannot contain recycled rubber and ointment, the surfaces must be free of cracks, crease, sticky, spray frost, brittle and other defects, in addition to sulfur and other ingredients with the agent, content of glue to the total mass of more than 70%.
