The angle valve is wrapped with several circles of raw material
When the 5 screw thread not to death by a twist, strong points, not necessarily is screwed to the screw does not move until no leakage, as long as the twist when you can feel anything to eat. Also note that the twist in the depth of two feet, such as cold and hot water mixing valve on the wire, twist when we must pay attention to keep a wall from the agreement, especially in the wall two faucet elbow inconsistent case depth,I say one more thing, not necessarily to the outlet valve angle upward, according to the actual situation, such as the length of the hose to hose, natural bending direction, such as hose longer, can make the angle valve outlet inclined downward, the hose drooping naturally after the lift, to avoid long-term stress caused accidents hose.
3, when you tie the tape to tighten the raw materials, so that the raw material with a tight stick attached to the thread, as far as possible tight, do not loose loose, wrapped around to use hand circling compression, you can also press while wrapping.4, as winding several layers, there is no hard and fast rules, to tighten, do not leak as the standard, but according to experience, usually need to wrap more than a dozen laps to ensure the sealing effect.
Three, the correct winding method:1 remove foreign body from the joint and keep it clean;2 note to the winding direction, angle valve angle valve for example, when screwed into the wall Lineisi thread is right, clockwise, the wound on the left belt angle direction is left counterclockwise winding, twist angle valve that tightening, not loose.
