The balcony with what material decoration?
It takes PVC as raw material, processed into the groove type profile, has the characteristics of light weight, easy installation, waterproof, anti moth, its surface color pattern change very much, and resistant to pollution, easy cleaning, sound insulation, heat insulation performance is good, especially in the process of adding new flame retardant materials. The energy from the fire that destroyed, use more safety. The utility model has the advantages of low cost and good decorative effect, so the utility model occupies an important position in the decorative ceiling material of the family decoration and becomes the leading material of the ceiling of the bathroom, the kitchen, the washing room and the balcony.
Ceiling material mainly has several kinds of mineral wool board, gypsum board, wood, plastic, glass, metal plate PVC etc..
When buying PVC ceiling profiles, you must ask the dealer for quality inspection reports and product inspection certificates. The appearance quality of visual surface should be smooth, no cracks, no scratches, can be assembled and disassembled freely, the surface of the surge is no scratches; hand percussion sound crisp surface. Check the test report, the performance index of the product should satisfy the heat shrinkage rate of less than 0.3%, the oxygen index is greater than 35% degrees Celsius above the softening temperature, ignition temperature above 3000 degrees Celsius, bibulous rate is less than 15%, the moisture rate less than 4%.
PVC ceiling profile of water, scrub resistance is very strong. Available daily use cleaning agents to clean after washing with water; the gap between susceptible to grease, available cleaning brush dipped in detergent scrub, rinse with water; attention to the lighting circuit not wet. If the PVC ceiling profile is damaged, it is very convenient to update. As long as the end of the strip is removed, the plate will be pulled out of the strip and replaced by the new plate. Replacement should be noted that the new plate and the old plate color should be the same, do not have chromatic aberration.
First of all, should be in the wall pop-up mark high wire, at both ends of the wall fixed pressure line, with cement nails and wall fixed firm. The plate is cut according to the actual size of the ceiling. The plate is inserted into the batten, and the panels are opened outwards. After installation, the nail is fixed and then inserted into the second plate...... The last piece of plate should be cut according to actual size, use a sharp knife to cut, cut down with steel wire, loading a bending plate can be inserted into the upper rabbet, Bahrain on both sides of the sealing strip.
