The mechanic says it would cost alot of labor anyway to replace the joints, so might as well replace the whole axle. I guess Isuzu‘s are complicated? Also, he said to just wait it out until it starts to make noise then replace it. Is there anything else that can be done besides just waiting for the axle to give out?
you're able to desire to purchase Orginal kit factors, that are greater high priced, or after marketplace factors, or re synthetic factors. call an area factors employer like NAPA, Autozone, and so on and verify the charges of their replace factors. Then call some shops and get a quote on changing the section with them grant the section, or you grant the section. Ask in the event that they are employing OE, Re synthetic or after marketplace factors. you are able to save particularly some money by skill of going to a great autonomous save.
Yeah! Go the a Better Mechanic If the CV Boots are torn and the CV Joints are Good? Get the Boots Replaced. Less the New CV Joints Axles.
The problem right now is that your CV joint boot covers are ripped. They do make slip on boot covers and give you new grease to grease the joints and then apply the new boot. The boot will slip over the joint and then snaps closed and some glue is provided to seal the connection point and a couple of clamps are included to tighten around the axles. This will work as a cheap fix, as long as your joints haven't been damaged yet or gotten any dirt into the joint yet. Your mechanic is right, it is a lot faster to just replace the whole axle. You save on labor plus you have all new parts to boot. That is the way to go, if you are planning on keeping the car for some time. good luck
