The plastic mould automatically dies and the product drops when it falls
We had the same problem before, when it was an ABS product, and then a 20 per cent PC in it solved the problem. We estimate that ABS is not hard enough.
Inevitably, we produce it, unless the manipulator has absorbed, we are all under the pad on a plastic bag to slide down, but definitely will have scars
I can see that you are also a mould-born, and I won't say anything about the second, the pneumatic secondary roof can adjust the rhythm of the blow. Where does the product meet with the mold, and where does it hit the mold when it is scratched or falling off? Can't make way? And one way is to use both hands, also just manipulator only suck in down, one of the product is a movement up and down, but the two products are formed a time order, the speed also have won't each other parts
You can't use the manipulator, the transmission belt is not even more. It's not possible to have a secondary top out, it's a problem that comes out of the top, and you've already written it yourself. A little want to buy something not give money, ha ha. Or semi-automatic. Use hand. Or you can try. Put slope slide board is a bit at the bottom of the mould, manipulate are placed at the side and operation side. When fall apart to make more hole products. Slide plate as close to the mold below (should consider a safe distance) to reduce product drop height.
