Home > categories > Mechanical Parts & Fabrication Services > Turning Tool > The process of the welding of the lathe, the more detailed the better.
Question:

The process of the welding of the lathe, the more detailed the better.

The process of the welding of the lathe, the more detailed the better.

Answer:

Will locate a good knife into the induction coil, stepping on foot switch, heat, when the temperature rose to over 800 degrees, in the case of welding pieces, solder melt completely, loosen the pedal switch, complete a welding tool.
The welding adopts high frequency brazing machine, and the insulation of heat insulation is used. Welding process: the blade and the cutter location is good, put on brazing, sprinkle with brazing powder, and then high frequency brazing machine, after the first water electricity, press the power switch button on the control panel.
Can use the welding tool holder first heat to 500-600 degrees Celsius, and then put the cutting head, reoccupy after burn red copper electrode with a moderate amount of borax flashing in the tool holder and the junction of the cutting tools, pay attention to the cutting head not to overheat, copper electrode borax to uniform.

Share to: