The processing method of the tile machine
Replace or repair the oil pump to improve the cooling system. Use a good hydraulic oil with a good viscosity. The pump speed is too low: the coupling or motor is faulty, the adjustment is not correct or the component is damaged: the pressure is adjusted incorrectly, the relief valve is damaged, the tank seal is leaking, adjust to the correct pressure, replace the relief valve, replace the seal or the cylinder.
The billet is soft. Filter cloth part of the paste was dead, the next model of the local filter hole blocked, clean up. System without pressure, pump reversal: wiring error, adjust the steering. Insufficient power: motor failure or low voltage, power supply or repair motor. Oil pump temperature is too high: oil viscosity is too low, the pump is damaged, the cooling is insufficient or interrupted.
Ingredients when the sand too much, resulting in tile sticky enough, when there is cracks in the cracks.
Watt plate and tile gap is too large, generally should be 1 ~ 5mm. The gap is too large will make the tile broken, the gap will be bad top tile. The tile tray is raised too fast or jitter. Adjust the corresponding air valve can be.
Mold release agent spray too little. Can be appropriate to increase the fuel injection pressure. The center of the tile plate is partial.
