Home > categories > Consumer Electronics > Monitors > The screen of the monitor is always automatically adjusted
Question:

The screen of the monitor is always automatically adjusted

I used a BENQ 17 inch display, recently formatted the win7 disk, so that the display automatically adjusted, the graphics card is Intel GMA 3100, change drivers are not good

Answer:

According to your description, please confirm whether the button is stuck; if not, this may be due to the display button by dust or fumes caused by internal adhesion caused by the display belongs to a hardware failure, you will need to display to the service center. Specific contact information can be found in BenQ China - service support - information inquiry - service network inquiries.
Adjust the resolution and refresh rate. In fact, most of these reasons are due to the automatic adjustment button on the front panel of the display. It does not have anything to do with what drive and what system you have.
Turn off the LCD's auto tuning function
The display always shows the automatic adjustment, and the following steps will be taken to troubleshoot it:1) try to restore the display factory settingsPress the button on the monitor (OSD menu) to find the restore factory settings, click on the confirmation of the existence of the fault.2) confirm whether the contact of the monitor line is in good condition and whether the connection line is damaged or notMake sure the connection is secure and replace the wire to confirm that the monitor is still working.3) verify that the auto key on the monitor is jammedCheck whether the auto key on the monitor is jammed or contact is abnormal. If so, the monitor needs to be repaired.4) if the above item does not solve the fault, replace a monitor to have a look. If the change after the failure is still, that is the graphics card hardware problems, at this point the need to repair the video card.

Share to: