The working steps of the balancing machine for automobile tires
The specific operation steps of the tire balancing machine are as follows: 1. Clear the soil, stone and old balance block on the wheel to be measured. 2. Check the tire pressure as necessary. 3. Select the cone according to the size of the center hole of the rim , Carefully tighten the wheel and tighten it with a large pitch nut. 4. Turn on the wheel balance machine power switch and check that the panel indicating the control unit is indicated correctly. 5. Measure the rim width L, rim diameter D (also from And the A, D, and L values ??are used to indicate the distance between the rim of the rim and the distance from the chassis, and then use the key or selector knob to align the measured values. 6 Put down the wheel guard, press the start button, wheel rotation, balance test start, automatic acquisition of data. 7 wheel automatically stops or hear "DI" sound After pressing the stop key and manipulate the brake device to stop the wheel, read the wheel inside and outside the unbalanced and unbalanced position from the pointing device. 8 Lift the wheel guard and slowly turn the wheel by hand. The rotation is stopped when the pointing device is instructed (sound, indicator light, brake, display dot matrix or display detection data, etc.). The weight of the side counter is displayed on the inside of the rim or the upper portion (clock 12 o'clock position) of the rim. Inside and outside with separate, balanced block card to be strong. 9 After installing the balance block, it is possible to create a new imbalance, and then re-balance the training until the unbalanced amount of <5g (0.3oz), indicating that the device shows "00" or "OK" to be satisfied. When the amount of imbalance is about 10G or so, if you can move along the rim edge of the balance block a certain angle, will be able to obtain satisfactory results. Practical experience, the faster the balance. 10 end of the test, turn off the power switch.
